The compact roller during the run-in period is more fragile than the roller used for a period of time. Because the various components of the roller cannot be well combined with each other, it is more likely to be subject to wear and tear during the work of the roller. The service life of the roller, during this period requires us to better protect the equipment, then we come to say how to protect the small roller during the run-in period.
1, The operator needs to understand the structure and performance of the machine and obtain certain operation and maintenance experience before operating the machine.
2, always check the lubricant, hydraulic oil, coolant, brake fluid and fuel oil (water) position and quality, and pay attention to check the machine's tightness. At the same time, the lubrication of each lubrication point should be strengthened. It is recommended that grease be applied to each lubrication point during the break-in period.
3, often observe the instructions of the instruments, abnormalities should be stopped in time to check, in the cause has not been found, the failure should not be ruled out before the operation.
4, keep the machine clean, timely adjustment, fastening loose parts. Minimize wear and parts loss due to loose parts.
5, the end of the run-in period, the machine should be mandatory maintenance. Do a good job of inspection and adjustment, and pay attention to the replacement of oil.
6, The work load during the run-in period should not exceed 60% of the rated work load, and an appropriate amount of work should be arranged to prevent overheating caused by continuous operation of the machine for a long time.